Several points of attention for maintaining and testing NTN bearings

1. In the process of using NTN bearings, regular cleaning is very important. How to clean the bearings accurately? When the bearing is first removed for inspection, first use the method of photography to make a good appearance record. Also, verify the amount of lubricant remaining and sample the lubricant before cleaning the bearings.

2. The cleaning of the bearing is divided into rough washing and fine washing, and the metal mesh frame can be placed on the bottom of the used container.

3. When rough washing, clean the grease or adhesive with a brush on the top of the oil. At this time, if the transfer bearing is moved in the oil, the rolling surface is damaged by foreign matter such as foreign matter.

4. When fine washing, slowly shifting the bearing in the oil, it must be forced to stop.

5. The cleaning agent used on weekdays is neutral non-aqueous diesel or petroleum, and sometimes uses warm alkaline liquid according to demand. Regardless of which cleaning agent is used, it is often necessary to filter and clean the cockroach.

6. Immediately after cleaning, apply anti-rust oil or anti-rust grease to the NTN bearing.

In order to make the imported bearings serve the mechanical operation for a longer period of time, it is necessary to perform regular inspections on the NTN bearings on a regular basis. Through the inspection, the problems caused by the mechanical operation can be effectively found, and the problems can be solved satisfactorily. Increased bearing life.

At the time of inspection, it is mainly correct to observe whether the rivet head of the bearing is skewed or loosely welded. The welding of the cage is good or bad. Whether the solder joint is too small, there is a problem that the solder is not strong, or the ball is caused by excessive soldering. They are all special places to pay attention to when testing imported bearings. There are still some issues to be aware of.

Local inspection of the bearing. First of all, the inspection of imported bearings in the environment should be carried out in a light environment, preferably astigmatism, in order to better observe the outside of the bearing and see that there are no cracks and other abnormalities on the surface. For example, wear, scratches and bumps in the mechanical cloud process can cause the bearing device to shift, resulting in poor position of the device, causing flat load and stress concentration, and the accuracy and service life of the molded bearing are reduced.

In addition, the working environment also pays special attention to moisture or contaminants, which are most likely to cause the bearing to rust. The rust is caused by poor installation of the NTN bearing, and early wear and tear, and the bearing will be directly scrapped. Therefore, pay special attention to waterproof and moisture during use.

For more information and purchase please visit: https://www.supplyforever.com