Precautions for use of engraving machine

Instead of manual operation, the engraving machine greatly improves the production efficiency and production quality, so it is more and more popular among many entrepreneurs. The engraving machine satisfies the various needs of customers well. For the customers to better use the engraving machine products. Whether it is stone carving or wood engraving machine, their basic operation methods are the same.

First, before starting the processing every day, the preparation work should be done: check the spindle cooling water; start the low-speed idle spindle for 5 minutes; if the engraving machine does not run for a long time, the engraving machine should be fully run-in before the new spindle motor needs to run. Hehe.

2. During the processing, attention should be paid to the protection of various equipment of the engraving machine.

1. Protect the tool setter and do not let it be excessively eroded by oil.

2. Pay attention to the control of flying debris. The flying debris is very harmful to the engraving machine. Flying into the electric control cabinet will cause short circuit. Flying into the guide rail will reduce the life of the lead screw and the guide rail. Therefore, when processing, it will be The main part of the machine is sealed.

3. When moving the light, do not pull the lamp, it is easy to pull the lamp.

4. During the processing, do not observe near the cutting area to avoid flying debris to the eyes. When the spindle motor is rotating, it is forbidden to perform any operation on the work surface.

5. When switching the machine door, do not open the slamming. During the finishing process, the impact vibration during the opening process will result in the surface of the machine being machined.

6. It is necessary to give the spindle speed, and then start the machining. Otherwise, because the spindle rotates slowly, the machining starts without the desired speed, and the motor is killed.

7. It is forbidden to place any tools or workpieces on the beam of the engraving machine.

8. It is forbidden to place magnetic tools such as magnetic suction cups and dial gauges on the electric control cabinet, otherwise the display will be damaged.

Note that the above matters can not only minimize the number of failures of the engraving machine, but also prolong the service life of the engraving machine. It is hoped that the operators of the engraving machine concerned to protect themselves and the safety of the machine during the operation.