Engraving machine maintenance

1. The continuous running time is less than 10 hours per day to ensure the cleaning of the cooling water and the normal operation of the pump. The water spindle motor must not be dehydrated, and the cooling water should be replaced regularly to prevent the water temperature from being too high. In winter, if the working environment temperature is too low, the water in the water tank can be replaced with antifreeze.
Second, each time the machine is used, it is necessary to pay attention to cleaning. It is necessary to clean the dust on the platform and the transmission system, and regularly and weekly (weekly) lubricate the transmission system (X, Y, Z three axes). (Note: X, Y, Z three-axis polished rods are maintained with oil; high-speed butter is added to the screw; in winter, if the working environment temperature is too low, the screw, polished rod (square rail or circular guide) should be cleaned with gasoline first. Then add the oil, otherwise it will cause the resistance of the machine transmission part to be too large and cause the machine to be misaligned.)
Third, the maintenance inspection of the electrical appliance is, must cut off the power supply, until the monitor has no display and the main circuit power indicator is off, before proceeding.
Fourth, the use of engraving machine in winter, if it is not a long time, do not need to control the water inside the water pipe to prevent freezing.
Maintenance:
Modification of engraving machine parameters (dimensional macro system): manufacturer parameter modification, (enter password: NCSTUDIO click "OK")
Table travel: (depending on the model of the machine)
System parameters: The first four items are selected on the default basis.
Motor parameters: 0.0062 if the lead is 10
If the lead is 5 then 0.003125
Take-off frequency: 300
Z axis maximum speed: 1000
Uniaxial acceleration: 400
Acceleration of the curve: 300 depending on the situation